Defender Security 812BF Especificaciones descargar pdf (Pagina 15)

OPERATING INSTRUCTIONS

Activating the red safety bar will stop the rollers immediately. To restart the rollers, just push the green

forward button or blue reverse button.

STOPPING - ROLLERS (ALL MODELS)

Pushing the red Emergency button on the roller control box will stop the rollers immediately. The

button will stay in the “pushed in” position, and will require resetting (pulling out) before being able to

restart the roller functions. NOTE - This button does not turn off the engine.

EMERGENCY STOPPING - ROLLERS (ALL MODELS)

EMERGENCY STOPPING - ENGINE (ROAD TOW MODELS)

Move the throttle lever to the ‘tortoise’ position.

Turn the ignition key to position O.

Should the entire machine need to be stopped in an emergency the red button on top of the engine

guard should be pushed. This will shut down the engine in the shortest possible time. The engine

cannot be restarted until the button is pulled out again to reset it.

EMERGENCY STOPPING - ENGINE (TRACKED MODELS)

LOCATE chipper on firm level ground.

CHECK chipper is well supported and

cannot move.

CHECK jack stand is lowered and secure

(road tow chipper only).

CHECK all guards are fitted and secure.

CHECK the discharge unit is in place and

fastened securely.

CHECK discharge tube is pointing in a safe

direction.

CHECK feed funnel to ensure no objects

are inside.

CHECK feed tray is in up position - to

prevent people reaching rollers.

CHECK controls as described below.

CHECK (visually) for fluid leaks.

CHECK fuel and hydraulic oil levels.

DAILY CHECKS BEFORE STARTING (ALL MODELS)

For parts location see diagrams on pages 3,4,6 & 7.

This is situated on the side of the hydraulic oil tank. When the chipper is

running, the oil temperature should not exceed 65

C. If it does, stop the

machine immediately. Failure to do so may result in damage. Overheating can

result from the chipper being worked extremely hard in hot conditions, as the

oil is not getting a chance to cool down. Stop the chipper and allow oil to cool

before continuing. If the temperature goes above 65

C and the machine is not

being worked hard or the air temperature is not particularly high this indicates

low oil, a jammed hydraulic motor or valve. Stop immediately and investigate.

When the chipper is on level ground, the oil level should sit between the red line

at the bottom of the gauge and the blue line at the top. If this level drops

significantly it indicates an oil leak. Stop immediately and investigate

HYDRAULIC OIL THERMOMETER/OIL LEVEL INDICATOR - TRACKED MODELS

These can be viewed through the wall of the tanks.

HYDRAULIC OIL / FUEL LEVEL INDICATOR - ROAD TOW MODELS

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 77 78

Comentarios a estos manuales

Sin comentarios

Defender Security 812BF Especificaciones Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Defender Security 812BF