Defender Security 812BF Especificaciones descargar pdf (Pagina 14)

OPERATING INSTRUCTIONS

MANUAL CONTROLS - 190TVGTR

GREEN

FORWARD

FEED

PANEL

BLUE

REVERSE

FEED

PANEL

RED SAFETY BAR

Control Box Diagram

Roller control boxes- two control boxes are located on either side of the feed tray. Their function is

to control the feed roller that draw material into the machine. They do not control the main rotor.

RED SAFETY BAR = This is the large red bar that surrounds the feed tray and side of the feed funnel.

The bar is spring loaded and connected to a switch that will interrupt the power to the roller. The

switch is designed so that it only activates if the bar is pushed to the limit of its travel. The roller will

stop instantly, but can be made to turn again by pressing either the GREEN FEED or BLUE

REVERSE control buttons.

RED SAFETY BAR TEST

To ensure the safety bar is always operational it must be activated once before each work session.

The rollers will not function until the bar is activated. This procedure must be repeated each time the

ignition is switched off.

Do not rely on the red bar to keep the roller

stationary if it is necessary to clear or touch the

roller. Always switch off the machine and remove

ignition key before approaching the roller.

There are two control boxes, located on

either side of the feed tray.

WARNING

DO NOT remove, jam, disable, bypass, override or otherwise

impede the effectiveness of the red safety bar.

GREEN BUTTON = Forward feed - Push the button once - this activates the roller and will allow you

to start chipping (if the rotor speed is high enough).

BLUE BUTTON = Reverse feed - allows you to back material out of the roller. The roller will only turn

in reverse as long as you keep pressing the button.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 77 78

Sin comentarios

Defender Security 812BF Especificaciones Pagina 14